High Accuracy Ultrasonic Sensor Distance Measurement Range 400…10000mm With PBT OR FRP Housing
Highlights
TECH-IN
Temperature compensate
LED for status indication
Battery powered
Minmal dead bands
Applications
Liquid and Solid Level Measurement
Tanks,Totes,Processing
Bulk Material Management
Factory automation
Position Detection
Avoid collision
| Ultrasonic sensor | | UM10000-SR80-AI | | Technical data | | | | General Specifications | | | Sensing distance | 400…10000mm | | Adjustment range | 400…10000mm | | Unusable area | 0…400mm | | Standard target plate | 100mm×100mm | | Transducer frequency About | 40 kHz | | Response delay About | 150ms | | Indicators/Operating means | | | LED yellow | solid: NO LED
flash: | | LED red | flashing: | | Electrical specifications | | | | Operating voltage UB | 10…30VDC ripple10%ss
13…30VDC(Analog output 0-10V) | | No-load supply current | ≤30mA | | Output | | | Output type | 1 analogue output 4---20mA | | Resolution | | Deviation of the characteristic
curve | ±1% of full-scale value | | Repeat accuracy | ±0.1% of full-scale value | | Load impedance | >1k Ohm | | Maximum switching current | 200 mA | | Temperature influence | ±1.5% of full-scale value | | Ambient conditions | | | Ambient temperature | -25…70℃ | | Storage temperature | -40…85℃ | | Mechanical specifications | | | | Protection grade | IP68 | | Connection | PVC cable,4-cables | | Material | | | Housing | PBT OR FRP | | Transducer | epoxy resin/hollow glass sphere
mixture; Polyurethane foam | 1 BN=BROWN
2 GN=GREEN
3 BU=BLUE
4 BK=BLACK | | Weight | 280g | | Compliance with standards and Directives | | Standard conformity | EN 60947-5-2:2007 | |
Adjusting the evaluation limits
The ultrasonic sensor features an analogue output with two teachable evaluation limits. These are set by applying the supply
voltage -UB or +UB to the TEACH-IN input. The supply voltage must be applied to the TEACH-IN input for at least 1 s.
indicate whether the sensor has recognised the target during the TEACH-IN procedure. The lower evaluation limit A1 is taught
with -UB, A2 with +UB.
Two different output functions can be set:
1. Analogue value increases with rising distance to object (rising ramp)
2. Analogue value falls with rising distance to object (falling ramp)
Evaluation limits may only be specified within the first 5 minutes after
Power on. To modify the evaluation limits later,
the user may specify the desired values only after a new Power On.
TEACH-IN rising ramp (A2 > A1)
- Position object at lower evaluation limit
- TEACH-IN lower limit A1 with - UB
- Position object at upper evaluation limit
- TEACH-IN upper limit A2 with + UB
TEACH-IN falling ramp (A1 > A2):
- Position object at lower evaluation limit - TEACH-IN lower limit A2 with + UB
- Position object at upper evaluation limit
- TEACH-IN upper limit A1 with - UB
Default setting
A1: unusable area
A2: nominal sensing range
Mode of operation: rising ramp
LED Displays (SR80 series no led) | Displays in dependence on operating mode | Red LED | Blue LED | TEACH-IN evaluation limit
Object detected
No object detected
Object uncertain (TEACH-IN invalid) |
off
off
flashes |
On
off
off | | Normal mode (evaluation range) | off | on | | Fault | on | previous state |
|
|
